Safety Notes - Trotec TTK 130 S Notice D'utilisation

Overview of contents
Safety notes ............................................ B - 1
Description of apparatus ......................... B - 2
Set-up...................................................... B - 2
Operation ................................................ B - 2
Commissioning........................................ B - 2
Shutting down ......................................... B - 3
Transportation of apparatus .................... B - 3
Care & maintenance................................ B - 3
Troubleshooting....................................... B - 3
Technical data ......................................... B - 3
Circuit diagram ........................................ B - 4
Spare parts list ........................................ B - 4
Spare parts overview............................... B - 4
Care and maintenance log ...................... B - 4
Pictures of apparatus
A
A.6 A.4
A.2
C
C.5
C.6
C.7
C.7
D
D.2
D.3
B - 1

Safety notes

This manual should be read carefully before set-
ting up / using the apparatus, and it should always be
kept close to the place of use or on the machine!
The apparatus was subjected to extensive material, function and
quality tests before delivery.
Nevertheless, dangers can arise from the use of the apparatus
if it is incorrectly used by untrained personnel!
Please observe the following instructions.
• The apparatus should not be set up and operated in
rooms where a danger of explosion exists.
• The apparatus should not be set up and operated in
saliferous environments or where the ambient air
contains oil, sulphur or chlorine.
• The apparatus must be placed upright in
a stable position.
• The apparatus should not be subjected to direct
contact with running water.
• Unrestricted access to the air intake and air exhaust
must always be guaranteed.
• The air intake side must be kept free of dirt and
loose objects.
• Never insert foreign objects into the apparatus.
• The apparatus must never be covered or transported
during operation.
B
A.1
A.3 A.7
A.5
C.1
C.2
C.3
C.6
D.4
D.1
Operating manual dehumidifier TTK 130 S
B.1 B.2
B.3
C.5
E
C.4
D.5
• All electrical cables outside of the apparatus are to be
protected from damage (e.g. by animals).
• Extension of the mains cables must be carried out with
due regard for the installed load of the apparatus, cable
length and application.
• The apparatus may only be transported upright, the
condensate container must be emptied before each change
of location.
• It is not permitted to operate or utilise the apparatus
in a manner other than that described in this manual.
All liabilities and warranty claims are invalidated in the event
of non-compliance with this stipulation.
Work on the refrigeration system and the electrical
equipment may only be carried out by an authorised
& qualified company!
A. Schematic representation of the principle of operation
A.1 Ventilator
A.2 Condensate container
A.3 Condenser
A.4 Evaporator
A.5 Compressor
A.6 Humid room air
A.7 Dehumidified room air
B. Set-up
B.1 Keep windows closed
B.2 Keep doors closed
B.3 Keep apparatus away from heaters or other
sources of heat
C. Operation
C.1 Air intake
C.2 Operating console
C.3 Condensate container (tank)
C.4 Rotary-type control switch
C.5 Front door
C.6 Tank warning lamp
C.7 Defrosting warning lamp
D. Set-up for operating mode
D.1 Anticlockwise limit - off position
(appliance turned off)
D.2 Clockwise limit - maximum position
(permanent operation)
D.3 Hygrostat-controlled mode
D.4 Reduce dehumidification performance
D.5 Increase dehumidification performance
E. Connection piece
This publication replaces all previous announcements. No part of this publication
may be reproduced, processed using electronic systems, replicated or distributed
in any form, without our written authorisation. Subject to technical changes. All
rights reserved. Names of goods are used without guarantee of free usage keep-
ing to the manufacturer's syntax. The names of goods used are registered and
should be considered as such. We reserve the right to modify design in the in-
terest of on-going product improvement, such as shape and colour modifications.
The scope of delivery may vary from that in the product description. All due care
has been taken in compiling this document. We accept no liability for errors or
omissions. ©TROTEC ®