Leckey squiggles Mode D'emploi page 9

7.12 Assemble the
tray
To attach the arms to the tray brackets,
loosen the ratchet handle (A), place the
mouldings to the inside of the tray plate so
the plastic teeth mesh. Replace the ratchet
handle on the outside. Repeat on other side.
Ensure both horizontal tubes are aligned so
they locate in the tray bracket receivers.
A
7.13 Attaching the
tray
The tray is attached to the seat by
inserting the tubes into the receiving
brackets. Once the tray is located in
position the ratchet handle (A) should
be tightened securely.
A
7.14 Attaching the grab rail
To attach the grab rail, insert the receiving
brackets (A) in the tray slot and secure with
the plastic knob (B). Repeat on the other side
and then slide the tubes into the receiving
brackets (A) and tighten the plastic knob (C).
C
A
B