Leckey squiggles Mode D'emploi page 8

7.9 Inserting Attachment
bolts on sandals
Insert the required bolt (a) along with the
retention plate (b). Place a rubber lid (c)
on, both, the top and bottom of the sandal.
Fasten using the four screws (d) provided.
To remove or replace the attachment bolt,
reverse the process.
1
A
B
2
C
D
3
C
D
7.10 Attaching the
sandals
Place the sandal so that the attachment bolt
goes through the slot in the footplate. To
secure, on the underside of the footplate
place the rubber washer (a), followed by the
metal washer (b) and then the knob (c) onto
the attachment bolt. To position the sandals
simply loosen the knob (c) under the footplate,
select the position you require and re-fasten
the knob.
1
A
B
C
2
C
7.11 Attaching the
ankle huggers
Slide the webbing through the slot in the
sandal. Loop the webbing back up and
through the bottom of the triglide. Then pass
the webbing through the top of the triglide.
Finally to lock the webbing in place, pass it
through the bottom of the triglide again.
Trim strap to required length.
1
2
3
4