Leckey squiggles Mode D'emploi page 10

7.15 Attaching the Long
Sitting Support
First attach the receiving brackets (A) to
the underside of the seat base. There is an
aluminium plate with pre-drilled holes onto
which they are attached. Open the receiving
brackets (A) under the seat base using the
hand knobs (B). Insert the long sitting support
bars. Adjust to the required depth and
retighten the knobs.
7.16 Interfaces for wheelchair and
pushchair bases
The set up and attachment of the
Squiggles seat to any mobility base should
be completed by a technically competent
person who is familiar with the set up of
the mobility base.
Interface "A" attachment to 12"
wide mobility base
The universal interface has been designed to
enable the Squiggles Seat to be attached to
any standard 12" (305mm) wide mobility base
that has been constructed from 1" (25.4mm)
side tubing.
Please refer to specific assembly
instructions supplied with your interface
for correct positioning on your base.
A
B
The Interface plate should be fitted by
a qualified technician who is technically
competent in the set up of the mobility base.
The position of push handles, leg hangers and
armrests on the mobility base may need to be
adjusted depending on the size and weight of
the child to ensure the stability of the seat.
Always refer to the mobility base
manufactures guidelines for correct set
up, paying particular attention to product
centre of gravity and stability.
Users should not be left unattended at any
time whilst using Leckey equipment.