Leckey squiggles Mode D'emploi page 5

Check parts
Congratulations on purchasing your
Squiggles Seating System. When opening
the boxes, cut the straps, taking care not
to cut through the tape as you may damage
some of the parts contained inside. All of the
parts will be contained in polythene bags
with each one clearly labelled. Carefully
remove them from the boxes
and check you have all the parts you
have ordered.
Safety First
Keep polythene bags away from children.
Some of the accessories will need to be
assembled before you attach the seat to the
base you have purchased. If you are fitting
the seat to a mobility base please ensure
you fit the interface plate to the mobility
base first. Instructions on how to attach the
interface to specific bases will be provided
with the interface plate. Once you have
checked all the components you are then
ready to assemble the Squiggles Seating
System and attach it to its base.
Multi-tool
A number of adjustments will require the use
of the multi-tool, which is supplied with each
seat and can be found in the back pack.
7.1 Locating the
backrest
The backrest will be folded down for
shipping. Raise it into the vertical position
and, while doing so, slide the inner tube (A)
into the receiving backrest pivot lock (B).
Secure the backrest in an upright position
by tightening the ratchet handle (C). Check
that it is secure and does not move when
pressure is applied.
B
A
C
7.2 Attaching the
shoulder support
Attaching the shoulder support will increase
the size of the Squiggles seat. Remove the
headrest bracket. This is studlocked into
position for safety reasons and will require
force to break. Insert the shoulder support
between the backrest and headrest bracket.
Reattach the headrest bracket using the
2 sets of screws (A & B) provided.
A
B