Leckey squiggles Mode D'emploi page 15

9.6 Backrest cushion
If you have lateral supports fitted to your
chair, adjust them to their maximum width
before attaching the backrest cushion.
Secure the cushion in place using the four
snap fasteners in the backrest moulding.
Align the top fasteners (A) first and snap in
place, then secure the lower fasteners. There
is a velcro panel provided in the lower part
of the cushion to accommodate positional
wedges/pads.
A
A
9.7 Lateral support padded
cushions
To attach the lateral support padded
cushions, simply slide the cushions on, with
the padded side towards the inside of the
seat. Thread the plastic buckle (A) through
the slot in the cover, then bring the two velcro
fastener straps around the bottom of the
moulding and attach them to the velcro panel
as shown. Close over the flap (B).
A
B
9.8 Shoulder Support
Cushion (if applicable)
If you have a shoulder support section, slide
the cushion over the assembly and secure
using snap fasteners. It is easier if you
loosen the shoulder support laterals first
(see section 10).
9.9 Chest harness
The chest harness can be attached by
clipping the male buckle (A) into the female
buckle at either side of the lateral supports.
A