Leckey squiggles Mode D'emploi page 13

9.2 One Piece Seat cushion
It is easier if you angle the back rest forward
before fitting the seat base cushion (see
section 10). Align the one piece seat cushion
on the seat base with the leg sections facing
forward. Secure at the back of the cushion
with the two snap fasteners (A) and then at
the sides (B). The cushion is then secured at
the front by hooking the two elastic tabs (C)
onto the hooks (D) under the seat.
A
B
9.3 Sacral cushion
Align the sacral cushion with the lower
backrest and press down to locate the
snap fasteners. Bring the lower tabs (A)
under the backrest and attach to the Velcro
on the upper tabs (B).
D
C
9.4 Pelvic harness
The Pelvic Harness is attached by sliding the
hip guides into the pockets (A) on the outer
face of the harness. It is attached in the
desired position by securing it to one of
the snap fasteners (B) on the adjustable hip
guide bracket. The buckle on the tie down
strap is clipped into a receiving buckle (C)
on either side of the seat base. Finally
secure the pelvic harness by attaching the
centre plastic buckle (D).
B
A
C
B
A
D
C