Clamp And Release Workpieces - Allmatic TITAN 2 Serie Instructions De Service

9 | Operation
9.2

Clamp and Release Workpieces

Clamp workpieces
NOTE
Avoid excessive torque and internal clamping.
Damage to the ALLMATIC TITAN 2 (CA).
Ø Set the torque spanner used to max. 30 Nm.
Where possible, machine clamped workpieces against the stationary jaw.
w Torque spanner set to max. 30 Nm.
1. Move the mobile jaw to the workpiece by turning the drive clockwise.
ð As soon as both jaws make contact, the ball coupling is released.
2. Continue turning until the torque spanner displays the maximum clamping force by clicking.
ð The workpiece is clamped with max. 40 kN.
[kN]
40
35
20
0 5
80 / 474
10 15 20 25 30
[Nm]
ALLMATIC
TITAN 2 (CA) Serie