Allmatic TITAN 2 Serie Instructions De Service page 476

LS 14500
Ø 4.2 min
5.5 max
(flat area)
1.35 ± 0.3
Ø 14.44 ±
50 ± 0.3
0.11
0.4 ± 0.1
Ø 7.5 ± 0.1
Dimensions in mm.
Storage
The storage area should be
●
clean, cool (preferably not
exceeding + 30°C), dry and
ventilated.
Warning
Fire, explosion and burn hazard.
●
Do not recharge, short circuit,
●
crush, disassemble, heat above
100 ° C (212 ° F), incinerate,
or expose contents to water.
Do not solder directly to the cell
●
(use tabbed cell versions instead).
Saft
Specialty Battery Group
12, rue Sadi Carnot
93170 Bagnolet - France
Tel.: +33 (0)1 49 93 19 18
Fax : +33 (0)1 49 93 19 69
www.saftbatteries.com
Voltage plateau versus Current and Temperature (at mid-discharge)
3.8
3.6
3.4
3.2
3.0
2.8
2.6
2.4
2.2
0.1 1
3.8
3.6
3.4
3.2
3.0
2.8
2.6
2.4
2.2
2.0
0.1 1
Restored Capacity versus Current and Temperature (2.0 V cut-off)
3.0
2.8
2.6
2.4
2.2
2.0
1.8
1.6
1.4
1.2
1.0
0.8
0.6
0.4
0.2
0.0
0.01 0.1
o
Doc. N 31064-2-0909
Information in this document is subject to change without notice
and becomes contractual only after written confirmation by Saft.
For more details on primary lithium technologies please refer to
Primary Lithium Batteries Selector Guide Doc N
Published by the Communications Department.
Photo credit: Saft
Société anonyme au capital de 31 944 000
RCS Bobigny B 383 703 873
Produced by Arthur Associates Limited.
10
Current (mA)
Typical discharge profiles at + 20°C
10 100
Time (hours)
1 10
Current (mA)
o 31048-2.
+ 70ºC
+ 55ºC
+ 20ºC
- 20ºC
- 40ºC
100 1000
1000 10000
100 1000