Between Surfaces - Allmatic TITAN 2 Serie Instructions De Service

ALLMATIC
With repeated clamping in the same GRIPP position, with the use of more than 2 GRIPPers per
jaw or with tempered material, the material displacement is made considerably more difficult,
i.e. the clamping force is generated considerably faster.
WARNING
Clamping of unsuitable workpieces.
Injuries due to bending, bursting or ejection of workpieces.
Ø Do not clamp tempered workpieces.
Ø Grind flame-cut contours with hardness with an angle grinder.
Limit the drive torque to max. 30 Nm.
Clamping with GRIPP jaws only in combination with GRIPP and hydro spindles. Other-
wise, correct operation is not ensured.
8.5.2

Between Surfaces

Fig. 18: Clamping between surfaces
When clamping between surfaces, no material displacement takes place, i.e. the clamping
force is built up extremely quickly. The torque of 30 Nm is reached after approx. 0.75 revolu-
tions of the pressure spindle.
Limit the drive torque to max. 30 Nm.
TITAN 2 (CA) Serie
Clamping | 8
EN
67 / 474