Plates And Gripp Jaws - Allmatic TITAN 2 Serie Instructions De Service

ALLMATIC
4. Move jaws forwards until they make slight contact. Align them parallel with each other
with a rubber hammer.
5. Insert all screws and tighten with 30 Nm.
6. Clamp ALLMATIC TITAN 2 (CA) with 4 – 6 kN.
7. Fully tighten screws.
TITAN 2 (CA)
Tightening torque
9.1.1

Plates and GRIPP Jaws

1. Turn out threaded plugs at the corresponding positions and keep in a safe place.
TITAN 2 (CA) Serie
K M
75 Nm 75 Nm
Operation | 9
L 160
75 Nm 120 Nm
EN
75 / 474