Clamping; Various Clamping Types; Conventional Clamping Of Workpieces; Complex Unmachined Part Clamping "Gripp - Allmatic TITAN 2 Serie Instructions De Service

8 | Clamping

8 Clamping
8.1

Various Clamping Types

Further information on the clamping types: www.allmatic.de under "Products".
8.1.1

Conventional Clamping of Workpieces

Fig. 12: Clamping jaws for conventional clamping
In the case of conventional clamping, parallel, pre-machined or level workpieces or materials
are clamped. Generally, conventional clamping is used for the second clamping process or for
workpieces with a surface quality of less than 0.05 mm.
8.1.2

Complex Unmachined Part Clamping "GRIPP"

Fig. 13: Complex unmachined part clamping GRIPP
With the support jaws, width-reduced jaws for GRIPP inserts or the GRIPP row, unmachined,
non-parallel workpieces or raw materials can be clamped.
GRIPP clamping:
– Support jaws are used to hold various GRIPP inserts (GRIPP inserts with thread or universal
GRIPP set).
– GRIPP inserts can be screwed in variably on a perforated grid in order to securely clamp a
wide variety of workpiece geometries.
62 / 474
ALLMATIC
TITAN 2 (CA) Serie