Manufacturer Information; Warranty And Liability; Copyright; Safety - Allmatic TITAN 2 Serie Instructions De Service

3 | Safety

Wear safety gloves!
Wear safety shoes!
2.3

Manufacturer Information

ALLMATIC-Jakob Spannsysteme GmbH
Jägermühle 10, 87647 Unterthingau, Germany
Phone: +49 (0) 8377 929-0
Fax: +49 (0) 8377 929-380
E-mail: info@allmatic.de
www.allmatic.de
2.4

Warranty and Liability

All information and instructions contained in this translation of the original operating manual
are provided on the basis of our experience and to the best of our knowledge. The technical
information and data described in this translation of the original operating manual are valid as
at 17.05.2016. Our products are subject to continual further development. We therefore reserve
the right to implement changes and improvements which we consider necessary. However, this
does not represent an obligation to extend these to products previously supplied. Therefore, no
claims can be derived from the information and descriptions given in this translation of the ori-
ginal operating manual. This translation of the original operating manual must always be
available in the vicinity of the clamping system.
2.5

Copyright

The contents published in this translation of the original operating manual are subject to
German copyright laws. The translation of the original operating manual is only intended for the
operator and the users of the ALLMATIC TITAN 2 (CA) clamping systems.
All forms of reproduction and forwarding to third parties require the prior approval of
ALLMATIC-Jakob Spannsysteme GmbH.
All copyright infringements may have consequences under penal law.
3 Safety
3.1

Area of Application

The ALLMATIC TITAN 2 (CA) is to be installed in enclosed spaces. The foundation for
installation must be level and clean and meet the specified requirements.
50 / 474
ALLMATIC
TITAN 2 (CA) Serie