Allmatic TITAN 2 Serie Instructions De Service page 70

8 | Clamping
Fig. 21: GRIPP inserts with rotated jaws
GRIPP inserts correctly mounted on the rotated
jaws
NOTE
GRIPP inserts with rotated jaw too close to the edge.
Danger of breakage of the jaws.
Ø Do not mount GRIPP inserts with rotated jaws in the outermost series of holes.
Fig. 22: Correctly mount GRIPP inserts
The flat side of the clamping inserts faces the
workpiece
NOTE
Clamping inserts incorrectly mounted
Danger due to slipping of the workpiece.
Ø Only use retractable clamping inserts with the flat side facing the workpiece.
70 / 474
GRIPP inserts mounted too close to the edge
The round side of the clamping inserts faces
the workpiece
ALLMATIC
TITAN 2 (CA) Serie