Sidestand; Central Stand - SWM Superdual E4 2017 Manuel - Utilisation - Entretien

Masquer les pouces Voir aussi pour Superdual E4 2017:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

SIDESTAND

A kickstand (1) is supplied with every motorcycle.
WARNING*: The stand is designed to support
the weight of the MOTORCYCLE ONLY. Do not
sit on the motorcycle using the stand for sup-
port as this could cause structural failure to
the stand and could cause serious bodily in-
jury.
1
EN - 10
WARNING*:
The motorcycle must ONLY be stood on its
kickstand AFTER the rider has dismounted.
Once the motorbike has been brought from
its rest position on the ground into vertical po-
sition, the driver has to raise the stand from
the lowered to the raised position with his left
foot.
WARNING*: A safety sensor (2) is fitted on the
motorbike, which allows starting it with the
stand lowered and the gear in neutral.
2
If a gear is engaged with the stand lowered,
the engine turns off.

CENTRAL STAND

- Grab the left knob (1) of the handle and the rear
left large handle (2).
- Press the tip of the central stand with the right
foot and lift the motorcycle upward and back-
ward at the same time, until it is fully lifted on
the central stand (3).
WARNING*: When the vehicle is parked on the
central stand, it is dangerous to sit on it, load-
ing your weight on the parking stand.
To lower the motorcycle from the central stand,
proceed as follows.
- Grab the left handlebar (1) grip and the rear (2)
left large handle.
- Push the motorcycle toward the front, until it de-
scends from the stand; the stand will automati-
cally lift.
1
3
3
2

Publicité

Table des Matières
loading

Table des Matières