ADJUSTMENT OF THE CONTROL LEVER AND FRONT
BRAKE FLUID LEVEL CHECK
The lever position can be adjusted (4 settings available)
to suit the rider hand size. To decrease the lever distance
from the handgrip, turn the adjuster (B) CLOCKWISE. To
increase the lever distance from the handgrip, turn the
adjuster (B) COUNTER CLOCKWISE.
The fluid level in the pump reservoir may never drop below
the notch visible on the sightglass (1) on the rear of the
pump body.
4
1
2
3
4
3
2
1
A decrease of the fluid level will let air into the sys-
tem, hence an extension of the lever stroke.
WARNING*: If the brake lever feels mushy
when pulled, there may be air in the brake
lines or the brake may be defective. Since it is
dangerous to operate the motorcycle under
such conditions, have the brake system im-
mediately checked by the SWM Dealer.
CAUTION*: Do not spill brake fluid onto any
painted surface or light lens.
CAUTION*: Do not mix two brands of fluid.
Completely change the brake fluid in the brake
system if you wish to switch to another fluid
brand.
CAUTION*: Brake fluid may cause irritation.
Avoid contact with skin or eyes. In case of con-
tact, flush thoroughly with water and call a
doctor if your eyes were exposed.
1
B
REAR BRAKE PEDAL POSITION ADJUSTMENT
The position of the rear brake pedal with respect
to the footrest may be adjusted according to the
individual needs.
For adjusting, proceed as follows.
- loosen the screw (1);
- turn the cam (2) in order to raise or lower the
brake pedal (3) within the range available (A);
- the operation done, tighten the screw (1). Once
this adjustment is completed, adjust the free play
of the pedal as follows.
2
1
3
A
EN - 35