Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
38
Adjusting Door Panels
Fine adjustments can now be made to align
the door panels.
1. To adjust the door panel horizontally, slide
the panel support screws left or right in the
slotted holes as desired. Have an assistant
hold the panel in place while you tighten
the support screws and insert and tighten
all remaining mounting screws.
2. To adjust the door panel vertically or back
and forward, loosen the screws in the
appliance door bracket. Move the plastic
rails to make adjustments as desired. Have
an assistant hold the bracket in place while
you tighten all the bracket screws.
NOTES
When adjusting the wine door panel, there will
be a small gap between the surface of the glass
Installing Door Trim
After panels have been adjusted, install the
decorative side trim on the doors.
To install, start at the middle and align the trim
then snap into place by pushing the trim
toward the back of the panel. Once the middle
is secure, continue the installation upward
until the remaining trim is completely secure.
Gap
Gap
Publicité
Table des Matières
