Installing Door Panels - Signature Kitchen Suite SKSCF1801P Guide D'installation

C

Installing Door Panels

Typical panel dimensions are based on an 84" (213.4
placement must be adjusted for panels exceeding
typical dimensions.
upper then lower drawer panel, if needed.
1. Place the door panel face down on a protected
surface.
2. Locate the correct side of the door panel template for
top and left sides of the panel.
3. Use the template to mark the correct screw locations
on the back of the panel.
top and right sides of the panel.
5. Use the template to mark the correct screw locations
on the back of the panel.
6. On refrigerator/freezer columns, begin inserting a
each side. On wine columns, use the third hole from
the top. Stop when the screws are 3/16" (4 mm)
proud of the panel. These will be the support screws
during the panel installation.
7. Insert the support screws in the slotted holes on the
appliance door mounting brackets so that the panel is
hanging on the door.
CAUTION
Beware of pinch points when installing door panels or opening
and closing doors.
Wine Column only.
Mounting door panel
37