Measuring Clearances; Removing/Assembling The Refrigerator Door Handles - Signature Kitchen Suite UPFXC2466S Manuel Du Propriétaire

Measuring the Clearances
Check the dimensions of the product and the
y
installation path to ensure there is sufficient
room to move the refrigerator through doors
or narrow openings.
If an opening is too narrow to fit the
y
refrigerator through, remove the refrigerator
doors. See Removing/Assembling the Doors
and Drawers in this manual.
The installation location chosen for the
y
refrigerator should allow space behind the
unit for connections and airflow and space in
front to open the doors and drawers.
24" (61 cm)
Removing/Assembling the
Refrigerator Door Handles
Tools Needed
3/32 in. Allen wrench
¼ in. Allen wrench
Removing the Handles
1
Loosen the set screws
Allen wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the refrigerator
2" (5.08 cm)
door and handle using
a
remove the mounting
fasteners.
Assembling the Handles
1
Assemble the mounting fasteners
both ends of the handle using a
Allen wrench.
2
Place the handle on the door by fitting
the handle footprints over the mounting
fasteners and
tightening
the set
screws
with a
Allen wrench.
INSTALLATION
NOTE
When it is necessary to move the
refrigerator through a narrow opening,
removing the doors is the recommended
procedure. If it is necessary to remove
the handles, follow the directions below.
1
/ in. Allen wrench, and
4
3
/ in.
32
8
3
with a / in.
32
that
at
1
/ in.
4