Worx VERSACUT WX420 Notice Originale page 12

the same as the steps used when installing the
blade.
NOTE: Remove both spanners after the
saw blade is tightly attached.
waRNING: When mounting, ensure
that the cutting direction of the teeth
(direction of arrow on saw blade) and the
direction-of-rotation arrow above the blade
guard match.
NOTE: Never use a blade that is too thick to
allow the blade clamping washer to engage
with the flat side of the spindle.
The table below gives you advice on
how to choose correct blade.
Blade type
tCt 24t
HSS 44t
Diamond
Recommended maximum material
thickness
12
Wood
Aluminum
PVC pipe (radius)
tile
Sheet steel
2. PaRaLLEL GUIDE (See Fig. D)
the parallel guide is used for making cuts
parallel to a work-piece edge at a chosen
distance and can be used from either side
of the base plate (9). Slide the parallel guide
(19) arm through the fixture (11) to achieve
the required cutting distance and tighten the
clamping screw (13) with the small "L" spanner
to lock into position. Do not over tighten.
the parallel guide enables exact cuts along
a workpiece edge and can also be used for
cutting parallel strips.
NOTE: Since the parallel guide clamping
screw is spring-loaded, the operator should
take care when unscrewing it completely as to
avoid losing the screw and spring.
Mini circular saw
Cutting material
Wood and aluminum
thin sheet steel and
aluminum, PVC pipe, plastic
Concrete, marble, tile ,
cement backerboard
0.91mm(20 gauge)
3. SawDUST REMOvaL (See Fig. E)
Your saw includes a vacuum adapter (20) that
attaches to the dust extraction outlet (7) on
the saw. this adapter port can be attached to
a vacuum cleaner (sold separately). the use
of the vacuum is strongly recommended as
it keeps the work area clean, dramatically
increases cut visibility and reduces airborne
dust. It also keeps dust out of the working
elements of the guard.
NOTE: If using the saw without a vacuum
attached, in some circumstances after lengthy
operation, dust can accumulate at the rear
of the base and prevent it from reaching full
depth. You can prevent this by occasionally
shaking the dust out.
4. PLaSTIC BaSE PLaTE COvER
(See Fig. F1, F2)
Your saw includes a plastic base plate cover
(21). Attach it to your saw's base when you are
cutting work pieces that have delicate surfaces
(finishes) such as vinyls, plastics, fiberglass,
laminate flooring and tiles that could easily be
scratched by the steel base.
27mm
OPERATION
3mm
1. TRIGGER SwITCH (See Fig. G)
13mm
the on/off switch is locked off to prevent
8mm
accidental starting. In order to turn the
machine on, depress and hold the lock off
switch (6), then depress the on/off switch (1)
and release the lock off switch. Your switch is
now on. to switch off, just release the on/off
switch.
NOTE: When the machine is not in use, the
lock off switch rests against the blade guard in
order to block the plunge function and prevent
the blade from being exposed unnecessarily.
2. SET THE BLaDE DEPTH
NOTE: the correct choice of cutting depth can
improve ease of cutting and cut quality.
Always use the minimum cut depth that is
required for your particular cut, which should
just cut through the material plus a small
allowance e.g. 3mm.
Excessive cutting depth increases splintering
in wood, chipping in tile and causes severe
EN