Worx VERSACUT WX420 Notice Originale page 10

weight. Supports must be placed under
the panel on both sides, near the line of cut
and near the edge of the panel.
e) Do not use dull or damaged blades.
Unsharpened or improperly set blades
produce narrow kerf causing excessive
friction, blade binding and kickback.
f) Blade depth and bevel adjusting locking
levers must be tight and secure before
making cut. If blade adjustment shifts
while cutting, it may cause binding and
kickback.
g) Use extra caution when making a
"plunge cut" into existing walls or other
blind areas. the protruding blade may cut
objects that can cause kickback.
SaFETY INSTRUCTIONS FOR PLUNGE-
TYPE Saw
a) Check guard for proper closing before
each use. Do not operate the saw if
guard does not move freely and enclose
the blade instantly. Never clamp or tie
the guard with the blade exposed. If
saw is accidentally dropped, guard may be
10
bent. Check to make sure that guard moves
freely and does not touch the blade or any
other part, in all angles and depths of cut.
b) Check the operation and condition of the
guard return spring. If the guard and the
spring are not operating properly, they
must be serviced before use. Guard may
operate sluggishly due to damaged parts,
gummy deposits, or a build-up of debris.
c) assure that the guide plate of the saw
will not shift while performing the
"plunge cut" when the blade bevel
setting is not at 90°. Blade shifting
sideways will cause binding and likely kick
back.
d) always observe that the guard is
covering the blade before placing saw
down on bench or floor. An unprotected,
coasting blade will cause the saw to walk
backwards, cutting whatever is in its path.
Be aware of the time it takes for the blade
to stop after switch is released.
Mini circular saw
GENERaL SaFETY waRNINGS FOR YOUR
LaSER
waRNING: Read all safety warnings
and all instructions. Failure to follow
the warnings and instructions may result in
serious injury.
Save all warnings and instructions for
future reference.
these lasers do not normally present an
optical hazard although staring at the beam
may cause flash blindness.
Do not stare directly at the laser beam. A
hazard may exist if you deliberately stare into
the beam, please observe all safety rules as
follows:
1. the laser shall be used and maintained
in accordance with the manufacturer's
instructions.
2. Never aim the beam at any person or an
object other than the work piece.
3. the laser beam shall not be deliberately
aimed at another person and shall be
prevented from being directed towards
the eye of a person for longer than 0.25
seconds area.
4. Always ensure the laser beam is aimed
at a sturdy work piece without reflective
surfaces, e.g. wood or rough-coated
surfaces are acceptable. Bright shiny
reflective sheet steel or similar is not
suitable for laser applications as the
reflective surface may direct the laser beam
back at the operator.
5. Do not change the laser device with a
different type. the manufacturer or an
authorized agent must carry out repairs.
6. CaUTION: Use of controls or adjustments
other than those specified herein may
result in hazardous radiation exposure.
EN