Intended Use - Worx VERSACUT WX420 Notice Originale

SYMBOLS
to reduce the risk of injury, user
must read instruction manual.
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
Laser radiation
Do not stare into beam
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
Mini circular saw
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

the machine is intended for ripping and
cross-cutting wood and other materials in
straight cutting lines, while resting firmly on
the work piece.
ASSEMBLY
1. INSTaLL/CHaNGE THE BLaDE
waRNING:
Before any work on the machine itself,
•
unplug the saw.
• Wear protective gloves when
mounting the saw blade. Danger of
injury when touching the saw blade.
• Only use saw blades that correspond
with the characteristic data given in
the operating instructions.
• Do not use grinding discs on this
cutting tool under any circumstances.
1) Insert the small "L " spanner(4) into the
center bolt hole on the back of the spindle
assembly. ( See Fig. A)
2) Place the large "L " spanner (3) into the
blade spindle clamping screw (17) , while
keeping the small "L " spanner in the
center bolt hole on the back of the spindle
assembly. turn the large "L " spanner
clockwise while holding the small "L "
spanner stationary. Remove the screw (17)
and the blade clamping washer (18). After
the washer is removed, slide the blade off
the spindle and through the blade slot at
the bottom of the saw.
( See Fig. B1, B2)
3) Clean the replacement saw blade and all
the clamping parts to be assembled. Slide
the saw blade up through the slot and fit
it onto the inner spindle. Assemble the
blade clamping washer (18) and the spindle
clamping screw (17). Use the two spanners
to tighten the spindle clamping screw
thoroughly. (See Fig. C)
the steps involved in changing the blade are
11
EN