Inserting Batteries - LaserLiner CondenseSpot XP Mode D'emploi

a
b
c
d
a Hold function
b Bar graph, condensation moisture indicator
1

Inserting batteries

Open the battery compartment and insert
batteries according to the symbols. Be sure
to pay attention to polarity.
3
Infrared temperature measurement / continuous measurement / Hold
1.
16
EN
m l k j
i
h
g
f
e
2.
c Temperature sensor (K-type) active
d Measured value in selected mode /
emissivity factor display/
mode display HEAT
e Mode display / storage location
f Quick emissivity display
g Infrared temperature measurement active
h Measured value, infrared temperature
i Measurement °C / °F
j
Battery charge
k Laser beam switched on,
temperature measurement (infrared)
l Memory function
m Continuous measurement active
2
ON / OFF
The device can also be switched on with the
MODE button (4). No measurement is triggered
and the last measured values are displayed.
Auto switch-off after 30 seconds.
Make sure that the humidity/ambient
!
temperature sensor (5) is folded in
during transport
Display of infrared temperature
(in all measuring modes)
Press button 9 for infrared
temperature measurement.
1.
ON
2.
1 sec