Sun Fire 880 Guide De Montage page 29

5. Remove the four lifting handles from the sides of the server.
a. Insert the screwdriver through one of the access holes on the outside of the
handle.
Using the access hole makes it easier to reach the opposite screw hole on the
inside of the handle to remove the screw. See the following figure.
b. Remove the two M4 screws that attach each handle to the server.
c. Save the eight M4 screws you remove. You will need to use the screws in step 7.
6. Secure the handles to the rack for safekeeping.
You must reattach the handles if you need to remove the server from the cabinet.
Installing the Server Into the Cabinet en-25