Sun Fire 880 Guide De Montage page 22

2. Measure the length of each slide.
Measure the distance from the inside face of the front bracket to the inside face of the
rear bracket. If this measurement is longer or shorter than the cabinet's depth, which
you measured in step 1, you must adjust the rear bracket on each slide to
accommodate the depth of the cabinet.
3. If required, adjust the rear bracket on each slide.
a. Extend the tray assembly until you can see the two 10-32 screws located on the
inside rear of each outer slide.
The screws on the inside of the outer slide (and the lock nuts on the outside of the
bracket) secure the rear bracket to the outer slide.
b. Loosen the two 10-32 screws and the lock nuts.
Lock nuts
c. Slide each rear bracket forward or backward as required to accommodate the
depth of the cabinet.
Slide each rear bracket and measure the distance from the inside face of the front
bracket to the inside face of the rear bracket.
Continue to slide the rear bracket and measure the distance from the inside face of
the front bracket to the inside face of the rear bracket until the measurement
equals the depth of the cabinet, which you measured in step 1.
en-18 Sun Fire 880 Server Rackmounting Guide • October 2001
Rear bracket
10-32 screws
Rear
bracket
Outer
slide