Sun Fire 880 Guide De Montage page 11

Caution – Be sure the cabinet is stabilized so that the it cannot move or tip forward
!
when one or more systems or devices are fully extended from the front of the
cabinet. The cabinet must be bolted securely to the floor or equipped with a sturdy
and extendable anti-tip leg. If there are feet beneath the cabinet to prevent it from
rolling, be sure the feet are fully extended downward to the floor. See the
instructions provided with the cabinet.
Caution – Install the server as low as possible in the cabinet. For best stability, do
!
not install the server above equipment that weighs less than the server. If you will be
installing two servers in a cabinet, install the lower server first.
Caution – To prevent the cabinet from tipping forward, do not attempt to roll or
!
move the cabinet after installing the server in the cabinet.
Caution – For proper ventilation and cooling of the server, be sure the cabinet and
!
the operating location comply with the requirements given in Appendix A.
Tools, Equipment, and Documentation
Required
The following tools, equipment, and documentation are required when
rackmounting the server:
Phillips No. 2 screwdriver
I
Phillips No. 1 screwdriver
I
Level
I
Flat blade screwdriver
I
Adjustable wrench
I
Masking tape or felt tip pen
I
Antistatic wrist strap
I
Antistatic mat
I
Sun Fire 880 Server Owner's Guide
I
Sun Fire 880 Server Service Manual
I
Installing the Server Into the Cabinet en-7