Publicité
changes in battery capacity, material characteristics, the strength of glued
joints and other unwanted effects.
All model flyers should behave in a way which minimises the danger to people
and property. Never act in any manner which will disturb other pilots, or have
an adverse effect on safe, orderly flying at the site.
Don't operate your model in the vicinity of overhead power cables, industrial
sites, residential areas, public roads, squares, school playgrounds, public
parks or sports fields etc.
Don't ignore our warnings. They refer to hazardous materials and processes
which, if ignored, can result in fatal injury or serious damage to property.
Every time you intend to fly the model, check carefully that all parts connected
to it are working correctly, including RC components, control surface horns
etc. Everything must be properly located and firmly secured. Check for
possible damage, and do not fly your model unless you are confident that
everything is in perfect order.
Whenever you are holding the model, make sure that you are standing on a
safe surface and cannot slip. Wear shoes with high-grip soles, such as
trainers.
Satisfy yourself that your frequency is vacant before you switch on. Radio
interference caused by unknown sources can occur at any time without
warning. If this should happen, your model will be uncontrollable and
completely unpredictable. Never leave your radio control system unguarded,
as other people might pick it up and try to use it.
If you are to fly your model safely and avoid problems, it is essential that you
are aware of its position and attitude throughout each flight - so don't let it fly
too far away! If you detect a control problem or interference during a flight,
immediately land the model to prevent a potential accident. Model aircraft must
always give way to full-size aircraft. Take-off and landing strips should be kept
free of people and other obstacles.
Your RC system can only work reliably if the batteries are kept fully charged.
Never use hot, faulty or damaged batteries. It is important to observe the
instructions supplied by the battery manufacturer.
Before every flight ensure that all functions are working correctly, and carry
out a range check.
Always switch on the transmitter first, then the receiving system. When
switching off, reverse the order: receiving system first, then the transmitter.
Check that the control surfaces work in the correct "sense", i.e. they deflect in
the direction which corresponds to the movement of the stick.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler Ident. # 0059183
4.2008
29
Publicité
