Attaching The Hose - Starmix ISC CLDC Serie Notice D'utilisation

Fig. 12: Battery compartment with a 36 V battery inserted

5.1.2 Attaching the hose

l WARNING!
Risk of electric shock
Risk of fire
If a non-electrically conductive hose is used, this can lead to
an electric shock and damage to the electronics in the vacuum
cleaner. This could cause a fire.
Only use the original electrically conductive hose intended for
the cordless vacuum cleaner.
Put the suitable hose onto the connection sleeve.
Ensure a secure connection.
5.1.3 Attach the cordless control *
To operate in the >AUTO< mode, the cordless control must be
installed.
You can find more detailed information in the manufacturer's
documentation.
5.1.4 Inserting the disposal bag
Vacuuming without a disposal bag is only permitted for dusts with
a concentrations of > 1 mg/m
Only class M vacuum cleaners with a special container and
rotating slider in the suction opening are suitable for the use of
PE emptying and disposal bags.
If necessary, remove the existing filter bag or empty the
container (seeKap. 5.5 „Removing the vacuumed material" on
page 31).
Select a suitable filter bag for your application.
NOTE
3
.
NOTE
To insert the bags, proceed as described in one of the following
sections:
Inserting a non-woven filter bag*
Use the non-woven filter bag only for dry vacuuming.
Push the flange completely over the suction port.
Turn the red rotating slider inside to CLOSE until it stops at
the ▲mark.
Inserting PE emptying and disposal bags*
Only class M and H vacuum cleaners with a special container
and rotating slider in the suction opening are suitable for
the use of PE emptying and disposal bags.
Turn the red rotating slider inside to OPEN until it stops at the
▲mark.
Push the flange completely over the suction port.
Place the upper bag opening over the edge of the container.
NOTE
NOTE
en - 29