Sleep Mode - Starmix ISC CLDC Serie Notice D'utilisation

If frequent changes between dry and wet vacuuming are
required, we recommend the use of a second filter set, preferably
polyester pleated filter cassettes.
5.4.3 Cleaning the pleated filter
(cleaning mode >OFF<)
r The fill level indicator lights up
Turn the cleaning mode rotating switch to the right to the >MAN<
position.
The filter cleaning is performed immediately.
The rotating switch springs back to >OFF<.
5.5 Removing the vacuumed material
r The fill indicator lights up although the filter has been cleaned
recently.
If the fill indicator lights up although the filter has been cleaned, the
container or disposal bag is full and must be emptied or disposed
of.
Proceed as described in one of the following chapters:
5.5.1 Emptying the container
Switch off the vacuum cleaner.
Open the closures.
Remove the lid and suction hose from the container.
Tip out the container.
5.5.2 Disposing of the non-woven filter bag
Switch off the vacuum cleaner.
Wear a suitable breathing mask.
Remove the suction hose.
Seal the suction port with a cap*.
Open the closures on the sides.
Remove the top.
Carefully pull the flange off the suction port and close the flange.
Dispose of the vacuumed material in accordance with the legal
regulations.
5.5.3 Disposing of PE emptying and disposal bags*
Move the switch to the >MAN< position.
Pleated filter cassettes are cleaned automatically.
Any residual dust in the filters falls into the bag.
Switch off the vacuum cleaner.
Wear a suitable breathing mask.
Remove the suction hose.
Seal the suction port with a cap*.
Open the closures on the sides.
Remove the top.
NOTE
Carefully close the PE emptying and disposal bag with the
enclosed sealing tape.
Carefully pull the flange off the suction port and close it.
Carefully remove the PE emptying and disposal bag from the
container.
Dispose of the vacuumed material in accordance with the legal
regulations.
5.6 Changing the pleated filter
Clean the pleated filter cassettes before changing the filter.
If necessary, remove the tool box from the vacuum cleaner.
Using a coin or similar object, turn the lock counter-clockwise by
90° and push it back (see general overview on page 3).
Lift up the cover and fix it in place with the locking clip.
Immediately close the removed pleated filter cassettes in a
dustproof plastic bag and dispose of them in accordance with
the regulations.
Insert the new pleated filter cassettes.
Lift the locking bar. Lower the cover and lock it by pressing
lightly.
Fig. 13: Locking bar
l CAUTION!
Danger due to falling cover
If the cover drops down under its own weight, there is a risk
fingers getting crushed or caught.
Proceed with caution.

5.7 Sleep mode*

Sleep mode is automatically activated if the vacuum cleaner has
not been used for 5 hours in >AUTO< mode. This avoids power
consumption thanks to the cordless control.
Sleep mode can be disabled in two ways:
Press the battery capacity button.
Set the operating mode / speed control dial to >OFF<.
en - 31