Starmix ISC CLDC Serie Notice D'utilisation page 32

5.8 Switching off the vacuum cleaner
Set the operating mode/speed control dial to the >OFF<
position.
The vacuum cleaner is switched off.
Remove the battery/batteries when the device is switched off.
Fix the suction hose to the rear wall of the container by inserting
it into the accessories depot*.
Remove the power tool.
6 Transit
Remove the suction hose.
Seal the suction port with a cap.
Place the top part on the container.
Close the closures on the sides.
Remove the battery/batteries
Place accessories in suitable plastic bags and seal the plastic
bags.
Plug the hose ends together so that no dirt particles escape.
Wrap the hose around the vacuum cleaner and clamp it to the
handle.
Fig. 14: Winding up the suction hose, step 1
32 - en
Fig. 15: Winding up the suction hose, step 2
Fig. 16: Tool box
l CAUTION!
Risk of tipping during transport
Transport no more than one tool box on the vacuum cleaner.
If the vacuum cleaner is subjected to impact, the batteries may
be damaged.
If possible, remove batteries before transport.
After transport with batteries inserted: check the batteries for
damage (e.g. broken plastic parts).
NOTE
* depending on equipment variant