Installing The Mini-Bowl* And Mini-Blade - KitchenAid 5KFP1335 Mode D'emploi

SETTING UP YOUR FOOD PROCESSOR

Installing the mini-bowl* and mini-blade*

1
Place the mini-bowl inside the work
bowl over the power shaft. Rotate the
mini-bowl until the tabs on the top
edge of the bowl drops into the indents
on the top of the work bowl.
3
Install the work bowl cover, being sure
it locks into place.
* Included only in model 5KFP1335
2
Insert the drive adapter into the
mini-blade, and place on the power
shaft. It may be necessary to rotate the
blade until it falls into place. Press down
firmly to lock it into place.
4
To remove the mini-bowl after
processing, remove the mini-blade
by pulling straight up on the cap. Then
lift the bowl straight up and out, using
the two finger grips located along the
top edge of the bowl.
21