Sonnenkonig SECCO 1000 Mode D'emploi page 47

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Operation at low temperatures with automatic defrosting
When „DEFROST" lights up on your appliance, the appliance automatically switches
to defrost mode to prevent frost from forming in the appliance� As soon as „DE-
FROST" goes out, the dehumidifi er resumes normal operation�
6. Water tank
If no direct drain is connected, the water runs into the water tank� The device has a
built-in water level sensor that switches off all functions after 3 seconds when the
water tank is full and emits a beep 15 times� At the same time, the water level indi-
cator lights up on the control panel�
7. Emptying the water tank
When the water level indicator fl ashes, the water tank is full and the appliance
does not continue running� To empty the tank, slightly press both sides of the tank
together and pull out the water tank parallel� Empty the water as shown in the il-
lustration:
1.
8. Direct discharge
If the water tank does not want to be used, a direct drain can be installed� For this
purpose, a hose (Ø 10 mm) is connected to the valve above the water tank� Make sure
that the hose is tightly connected and cannot slip�
1.
2.
2.
Hose for
Direct drainage
not included
47
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Secco 20001010200210102102

Table des Matières