Usage - Sonnenkonig SECCO 1000 Mode D'emploi

4. USAGE

EN
1. Timer
Power-Off -Timer: When the unit is on, the Timer button can be pressed to control
when the unit should be turned off �
Power-On-Timer: When the unit is off , the Timer button can be pressed to control
when the unit should be turned on�
The time can be set between 1-24 hours�
When the timer is turned off , the display will show the humidity again after 5
seconds�
2. Dehumidifi cation
Dehumidifi cation can be set on the control panel using the „Up" and „Down" but-
tons between 30-90% or „CO" for continuous� As soon as the humidity drops to the
set humidity level, the compressor switches off and the fan continues to run for
good air distribution�
3. Laundry drying (SECCO 2000)
The device runs on a high level independent of the humidity of the air in order to
remove the moisture from the laundry�
4. Display
• When the unit is connected, it shows the current humidity�
• When the humidity is set, the display shows this setting�
• When the timer is set, the display shows the remaining time�
• If the humidity is below 35%, the display will show „LO"�
• If the humidity is above 95%, the display shows „HI"�
• „COMP" lights up normally = compressor is being used�
„COMP" fl ashes regularly = compressor is not being used�
NOTE: DO NOT ALLOW THE DEVICE TO BE USED BEFORE
THE FIRST COMMISSIONING AT LEAST 12 HOURS.
46