Warning Label - Metabo HPT NV 75AN Manuel D'instructions Et De Sécurité

English
4 Remove the jammed nail with a slotted screw
driver.
Slotted Screw Driver
Nail
5 Cut the deformed collated wire with nippers.
Correct the deformation.
6 In case of frequent jam, contact a metabo HPT
authorized service center.
2. Inspecting the push lever
1 DISCONNECT AIR HOSE.
2 Clean the push lever sliding part.
Lubricate it with metabo HPT pneumatic tool
lubricant.
Lubricate
3. Inspecting the feeders
1 DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with metabo HPT pneumatic tool
lubricant.
Knob
Nail
Guide
Push Lever
20
000Book̲NV75AN̲US.indb 20 000Book̲NV75AN̲US.indb 20
4. Inspecting the magazine
5. Storing
1
Disconnect
air hose

6. WARNING LABEL

1
Disconnect
air hose
3 Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and
shafts.
Nail Guide
Nail Stopper
Feeder Shaft
Feeder
4 Lubricate the feeding surfaces of the nose and
the nail guide after cleaning.
This promotes smooth operation and prevents
rust.
CAUTION
Check that the nail stopper slides smoothly by
pushing them with fi nger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove dust or wooden tips
which may have accumulated in the magazine.
When not in use for an extended period, apply a
thin coat of the lubricant to the steel parts to avoid
rust.
Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach children.
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a metabo HPT
authorized service center.
Feed Piston
Warning
Label
2018/03/22 15:46:41 2018/03/22 15:46:41