Steam Function - Krups XP2280 Manuel D'utilisation

English
Fill the water tank and turn on the appliance (Fig. 1, 2, 3 and 4). During the preheating of the
Espresso
appliance, the
Place a soft pod in the filter holder. Never use two pods together.
Be sure to place all the paper inside the filter holder, otherwise there might be leaks.
If the pod is not positioned correctly, the result in the cup will not be satisfactory.
Follow the steps in Figures 7 to 11 for preparing an espresso.
Note: Once you have obtained the sufficient amount of coffee, you can stop the flow at any time by
pressing the button (fig.8).
INDIVIDUAL PROGRAMMING OF THE VOLUME OF WATER:
To change the preprogrammed amount of water (50 ml per cup is the factory setting), proceed as follows:
Fill the water tank and turn on the appliance (Fig. 1, 2, 3 and 4).
Put a spoonful of coffee in the filter holder using the measuring spoon or use an E.S.E. or soft pod.
Put the filter holder in place by turning it to the right as far as possible, up to the stop (Fig. 7).
Place a cup under the filter holder.
Hold down the
When the desired amount of espresso is obtained, press the
saved automatically.
The next time you press the
You can programme for 2 cups in the same manner, by pressing the

3 . STEAM FUNCTION

Steam is used to foam up the milk (for example, to make a cappuccino or a cafe latte).
To produce steam, the pump works by emitting an intermittent noise.
After using the steam function, the appliance cools automatically by pumping cold water
through the heating system. During the pumping cycles, the excess steam in the heating system is
released with the hot water into the drip tray.
The release of steam and the accompanying noise are required for the appliance to cool
down.
WARNING:
During and after using the appliance, the metal parts of the steam nozzle can
become very hot.
USING THE STEAM NOZZLE TO FROTH MILK
Fill the water tank and turn on the appliance (fig.1, 2, 3 et 4).
After a few moments, the
Press the button (fig. 12). During the pre-heating, the
Move the steam nozzle towards the outside of the appliance.
Pour 60 to 100 ml of very fresh, very cold milk in a narrow container of about 1/2 litre and which can
pass under the steam nozzle. The milk (UHT or pasteurised) and its container should be quite cold.
As soon as the appliance reaches the right temperature, the
steadily.
Immerse the steam nozzle into the milk and turn the knob to
The Espresso LED and the pictogram
flash after a few moments.
For best results, hold the nozzle towards the bottom of the container for about 25 seconds while the
milk heats up (without however touching the bottom of the container). Then, bring the container down
94
LED flashes.
button ( > 3 sec) until the pictogram
, button, you will obtain the most recently recorded amount.
Espresso button glows steadily
remain steady when the steam begins to be produced and can
flashes quickly. The coffee flows out.
. button. This amount will then be
button ( > 3 sec).
Espresso LED and the pictogram
Espresso LED and the
position (fig.13).
flash.
pictogram glow