Krups XP2280 Manuel D'utilisation page 101

English
Espresso
Once the LED becomes steady, turn the knob to
the nozzle and then turn it back to "0" position
The appliance is descaled and ready to be used again.
6.GUARANTEE
Your appliance is covered by guarantee but any connection or handling error or any use of the
appliance other than that described in these instructions renders the guarantee invalid.
This product has been designed for domestic use only. Any commercial use, inappropriate use or
failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee
will not apply.
No repair made because of a lack of descaling will be covered by the guarantee.
If you have any problem or query please contact our Customer Relations Team first for expert help
and advice.
0845 330 6460 - UK
01 677 4003 - ROI
or consult our web site: www.krups.co.uk
7. TROUBLESHOOTING
Problems
The espresso is not
hot enough.
The Espresso LED and
the pictograms
and flash and
the appliance does
not work.
The filter holder is
blocked
The espresso flows
too slowly.
The water does not
run through.
98
Possible causes
The cups and the filter
holder are cold.
The knob has been turned
to the position.
You forgot to unlock the
filter.
The espresso ground coffee
is too fine, too oily or floury.
The flow rate depends on
the fineness of the coffee
used and can vary when
preparing the espresso
The filter holder is dirty.
The water drip-through grid
is clogged.The water drip-
through grid is clogged.
No water in the tank.
Tank poorly fitted.
The filter is clogged. The
espresso ground coffee is
too fine.
Your device is scaled up.
The Claris cartridge has
been replaced but not
primed.
position and let 100 ml of water flow through
Solutions
Preheat the accessories: cups and filter holder
(see paragraph 6).
Turn the knob to the "0" position ( f i g. 15) .
Press the "OPEN" button lightly while turning the
filter holder to the left.
Choose a slightly coarser espresso ground
coffee
.
Clean your filter holder (see paragraph 4).
When the appliance has cooled, clean the
brewing head with a damp cloth. (fig.21).
Fill the tank.
Press down firmly on the tank.
Clean the filter holder (see paragraph 4) and try a
less fine espresso grind.
See paragraph 5.
See paragraph 1