Krups XP2280 Manuel D'utilisation page 102

Problems
Water leaks from the filter
holder after an espresso
has been made.
Coffee grounds in the
cup.
The water tank leaks
when it is moved.
Water leaks under the
appliance.
Water leaks under the
drip tray
Crackles are heard in
the filter holder.
The pump is abnormally
noisy or the Espresso LED
and the pictograms
, flash.
The cups are not filled
equally.
Lots of water on the
ground coffee, in the
filter holder.
The espresso leaks on
the sides of the filter
holder.
Your espresso tastes
bad.
Possible causes
Premature formation of
scale due to especially hard
water.
The filter holder is clogged.
The grind is too fine.
The valve at the bottom of
the tank is dirty or defective.
The valve is blocked by
scale.
Internal leak.
Water can be present
and/or flow when you
remove the drip tray.This is
not a sign of a leak.
Normal phenomenon:
caused by the filter holder
security lock.
No water in the tank.
, Tank poorly fitted.
The Claris cartridge is not
filled with water.
The filter holder is clogged.
Coffee insufficiently tamped
down.
Insufficient amount of coffee.
The filter holder has not
been properly positioned.
The edge of the filter holder
is clogged by ground
coffee.
Pod poorly positioned in the
filter.
The brewing head seal is
dirty.
The brewing head seal is
defective.
After descaling, the rinsing
was not performed properly.
Solutions
Descale your appliance according to the
manual (see paragraph 5).
Clean the filter holder with hot water. Press
"EJECT" to eliminate the remnants of the
grounds. Shake to drain the water.
Use a slightly coarser espresso grind.
Wash the water tank and operate the valve
at the bottom of the tank with your finger.
Descale the appliance (paragraph 5).
Check the position of the tank. If the fault
persists, do not use the appliance, contact
an approved service centre.
Stop the appliance, fill the water tank and
turn the machine back on.
Press down firmly on the tank.
Please refer to paragraph 1.
Clean the filter holder (see paragraph 4).
Tighten the filter holder as far as it will go,
up to the stop (fig.7).
Add more espresso ground coffee.
Put the filter holder in place and lock it (by
turning it to the right as far as it will go, up
to the stop) (fig.7).
Remove excess coffee.
Place all the paper inside the filter holder.
Clean the seal with a damp cloth.
Contact a Krups approved service centre.
Rinse the appliance according to the
manual (see paragraph 5).
Français English
99