Making An Espresso - Krups XP2280 Manuel D'utilisation

English
C. RINSING YOUR APPLIANCE (to be done on first use and after each cleaning /
descaling operation)
- RINSING OUT THE ESPRESSO CIRCUIT
Then rinse the appliance. To do so:
Turn on the appliance and fill the water tank (Fig. 1, 2, 3 & 4).
Insert the filter holder (without ground coffee) in the appliance (Fig. 7).
Place a container of sufficient volume under the filter holder.
As soon as the appliance reaches the right temperature, the
pictograms and
Press the button and let the water run out into the container (fig.9).
Repeat this operation 5 times.
If necessary, stop the operation by pressing the
the operation (fig.9).
Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and
turn it to the left (fig.10).
- RINSING OUT THE STEAM CIRCUIT.
Before using the steam function for the first time, the steam circuit should be cleaned.
Fill the water tank. Make sure that the steam function dial is in O position.
Turn the appliance on by pressing the
Place a container underneath the steam nozzle.
When the Espresso light indicator glows, press the
on the display will begin to blink.
When they have stopped blinking, turn the dial to the
steam is generated.
Keep the steam production going for at least 30 seconds.

2 . MAKING AN ESPRESSO

Before making an espresso, make sure the steam knob on the left of the appliance is in 0
position.
In order to release all the aromas of the coffee and ensure your complete satisfaction, this machine pre-
brews each coffee. The pump works for 3 seconds, stops the following 3 seconds and then the cycle
continues until the end of the preparation.
PREHEATING THE ACCESSORIES
For best results, we recommend that you first pre-heat the accessories (filter holder and cups)
without ground coffee. To do this:
Fill the water tank and turn on the appliance (Fig. 1, 2, 3 and 4).
Put the filter holder in place and place the cups underneath.
As soon as the appliance reaches the right temperature, the
pictograms and
Then press the
Once the cup(s) are filled with hot water, remove them.
Unlock the filter holder: press the "OPEN" button by turning the filter holder to the left and remove
it from the appliance.
WITH GROUND COFFEE
The type of ground coffee you use will determine the strength and taste of your espresso.
Fill the water tank and turn on the appliance (Fig. 1, 2, 3 and 4). During the preheating of the
appliance, the LED flashes.
92
are displayed.
Espresso
are displayed.
or button (fig.8 ou 9).
button to empty the container and then resume
button.
button: the Espresso light indicator and the
position and allow the water to flow until
Espresso LED glows steadily and the
Espresso
LED glows steadily and the
pictogram