Hot Water Function; Steam Function - Krups XP6025 Mode D'emploi

KR_ESPRESSO_XP6025_NAFTA_8080011600-02 03/07/12 17:49 Page16
English

2. HOT WATER FUNCTION

The production of hot water is ideal for preparing tea, infusions or pre-heating a container.
n Check the water level in the tank. (fig.1).
n Make sure that the frothing nozzle is securely fitted to the adjustable spout.
n Check that the rotating control button is set to PENDING (
SELECTION button (h3) is at ESPRESSO/HOT WATER
n Switch the machine on by turning the START/STOP (h5) button to the right to the (I) setting.
n The TEMPERATURE light (h4) flashes.
n Wait until the TEMPERATURE light (h4) stops flashing.
n Place a cup or bowl under the adjustable spout and make sure it is correctly positioned.
n Turn the control button to HOT WATER
n When the required quantity of water is reached, turn the rotating control button to PENDING (
stop the flow of hot water (fig.4).
n The pump stops immediately and the spout circuit is closed.
IMPORTANT
It is possible that some steam may be released from the water tank. This is completely normal.
n You can now use the water collected to prepare your hot drink.

3. STEAM FUNCTION

Steam production is ideal for making the milk froth used in milk drinks (cappuccino, latte machiatto, hot
chocolate, etc.).
n Check the water level in the tank.
n Make sure that the frothing nozzle is securely fitted to the adjustable spout.
n Check that the rotating control button is set to PENDING (
n Switch the machine on by turning the START/STOP (h5) button to the right to the (I) setting.
n The TEMPERATURE light (h4) flashes.
IMPORTANT
If the rotating control button (d) is not at PENDING (
quickly and heating does not occur.
n Turn the TEMPERATURE SELECTION button (h3) to STEAM
n Wait until the TEMPERATURE light (h4) stops flashing.
n Place a container or empty cup under the spout.
n Open the spout circuit by turning the control button to STEAM
that may be in the circuit (fig.3).
n Turn the control button back to the left to PENDING (
n Pour the milk into a container and plunge the frothing spout into the container without touching the
bottom to pevent blocking the steam flow.
Advice
For a better result, use refrigerated milk, a cold stainless steel container and measure approximately
20 to 30 ml of milk per drink.
n Wait until the TEMPERATURE light (h4) stops flashing.
n Turn the control button back to STEAM
16
●
) and that the TEMPERATURE
.
(fig.3). The hot water flows through the spout.
●
).
●
), the TEMPERATURE light (h4) flashes
.
to release any remaining water
●
) (fig.4).
(fig.3).
●
) to