Making An Espresso - Krups XP52 Serie Mode D'emploi

n Empty the container and unlock the filter holder: press the "OPEN" button on the filter holder and turn
it to the left (fig.10).
- RINSING OUT THE STEAM CIRCUIT.
Before using the steam function for the first time, the steam circuit should be cleaned.
n Fill the water tank
n Turn the appliance on by pressing the
n Place a recipient underneath the steam nozzle.
n Turn the switch to the
n When the
button has stopped flashing, turn the switch to the
steam is formed.
n Keep the steam production going for at least 30 seconds.

5. MAKING AN ESPRESSO

In order to extract the maximum flavor from the beans, this machine pre-infuses each cup. The pump works
for 3 seconds, pauses for 3 seconds, and then continues until the cup is finished.
PREHEATING THE ACCESSORIES
For the best results, we recommend that you preheat the accessories (filter holder and cups) without
espresso ground coffee. To do so:
n Fill the water tank with fresh cold water and turn the machine on (fig 1-4).
n Put the filter holder in place, place the cups below.
As soon as the required temperature is achieved, the light will stop flashing.
n Turn the dial to the "coffee" position (fig.8).
n When the cups are filled with hot water, turn the dial to the "off" position (fig.9).
n Remove the cups, taking care to not spill the water.
n Unlock the filter holder by pressing the "OPEN" button on the handle while turning the handle to the
left to release, and remove the filter holder from the machine (fig.10).
Note: Use the cup warming tray to warm espresso cups.
WITH GROUND COFFEE
The type of coffee you choose will determine the strength and taste of your espresso. Always
use espresso ground coffee. Do not use instant coffee, cafetiere coffee or filter coffee.
n Fill the water tank and turn the machine on (fig. 1, 2, 3 and 4). During the preheating of the appliance,
the light flashes.
n Using the measuring spoon, place the espresso ground coffee in the filter holder: one spoon (full to the
brim) per cup (fig.5).
n Remove any excess espresso ground coffee from the edge of the filter.
Important: Do not tamp the coffee down in the filter holder. The coffee is automatically
tamped using the KTS "Krups Tamping System".
n Insert the filter holder in the device by turning it to the right as far as it will go, up to the stop
(fig.7).
n Put one or two cups under the filter holder (fig.8).
As soon as the appliance reaches the required temperature, the light stops flashing.
n Turn the switch to the "coffee" position (fig.8).
n When you have the desired amount of coffee, turn the switch to the "off" position (fig.9).
n Unlock the filter holder: press "OPEN" while turning the filter holder to the left and remove it from the
machine (fig. 10).
button.
position, the button starts to flash.
position and let the water run until
English
6