Printing Measured Values (Print/Print Mem Key) (C.a 6547) - Chauvin Arnoux C.A 6545 Notice De Fonctionnement

a programmed-time test
To exit the R(t) mode and return to the normal memory recall condition (OBJ:TEST), press the
R(t) key again.
To exit the MR function, press MR again or turn the switch.

6.3. PRINTING MEASURED VALUES (PRINT/PRINT MEM KEY) (C.A 6547)

If you use a serial printer, choose the appropriate communication speed in the SET-UP menu, between
300...9600 bauds, then program the printer for the format used by the instrument (see § 6.1).
If you use a parallel printer, you must adjust the speed to "Parallel" in SET-UP and use the series/parallel
adapter sold optionally (connect in series the cable delivered + adapter + Centronics printer cable).
Two print modes are available:
Printing of the present measurement result (PRINT)

 Printing of stored data (PRINT MEM)
The COM symbol in the display indicates data transmission to the printer.
6.3.1. IMMEDIATE PRINTING OF THE MEASUREMENT (PRINT KEY)
Following a measurement or after access to the MR mode (Memory Recall), the PRINT function is used
to print the measurement results.
As soon as the key is used, it prints:
 1 group of measurements (U/R/DAR/PI/DD/date/time) for a normal test,
the R(t) values if the "Programmed time test"

To stop printing, change the position of the rotary switch.
Depending on the function used, the following models are obtained.
, the R(t) values can be accessed by pressing the R(t) key (see § 4.3).
67
function was activated.