Memory Deletion - Chauvin Arnoux C.A 6545 Notice De Fonctionnement

4.7.1. MEMORY DELETION

In SET-UP, press the MEM key:
The MEM symbol fl ashes,

ALL is shown fl ashing on the small display,

 The main display indicates cLR.
To delete the entire memory, press again on the MEM key for 2 seconds:
The MEM symbol is displayed steady,

ALL is shown constant on the small display,

 The main display indicates FrEE.
To delete the content of a specifi c OBJ:TEST:
Select the number using keys

FrEE or OCC is shown on the main display,

 Press again on the MEM key for 2 seconds to delete:
 The OBJ:TEST is indicated on the small display,
The main display indicates FrEE.

4.7.2. OUTPUT IN BAUDS (RS 232)
In SET-UP, press the PRINT key:
The main display indicates the output in bauds, i.e. 300, 600, 1200, 2400, 4800, 9600 or Parallel.
On the small display, baud appears. The value may be modifi ed using the keys
The "Parallel" display means that the parallel mode is selected, to print on parallel printers via the serial/
parallel adapter (RS 232-Centronics).
4.7.3. DEFAULT CONFIGURATION OF THE DEVICE
In SET-UP, 3 rd press on the
The small display shows SEt,

 The main display shows DFLt (fl ashing).
Press on START to reconfi gure the device using the default parameters (see previous table).
4.7.4. VOLTAGE DISTURBANCE LIMIT
th
In SET-UP, 5 press on the
The small display indicates dISt,

The main display shows 0.03U (fl ashing),

 Modify this value if necessary using the
Note: This adjustment provides the best compromise between the measurement settling time and the
presence of external parasitic voltages (§ 3.2).
If no parasitic voltage is present, this value will be chosen equal to 0.03 to obtain a rapid
measurement settling time.
and ,
key:
key:
key (choice between: 0.10 - 0.20 - 0.03).
60
and .