Symbols And Warnings; Tool Installation And Starting; Installation And Starting Operations; Warning For The Tool Starting - CAMPAGNOLA T-CAT Manuel D'utilisation Et D'entretien

Symbols and warnings

General warning
Compulsory reading of the Use
and Maintenance Manual
Compulsory head protection

4 TOOL INSTALLATION AND STARTING

Installation and starting operations

• Plug the battery (16) into its seat inside the tool housing, until you hear a click.
• Switch on the tool by means of the ON/OFF button (10). The display (9) lights up after a beep.
• The tool is ready to be used
4.1.1

Warning for the tool starting

WARNING!
Before starting the motor, check that the chain (1) does not touch anything.
•
• Do not work on a tree or a ladder, since it would be extremely dangerous.
• Before starting any cutting task, it is necessary to wear protective clothing.
Check whether all the safety and protection devices are efficient and correctly assembled.
•
Check the bar (2) and the chain (1) for proper assembly and the chain (1) for adequate tension.
• Check all the fixing screws for correct tightening.
4.1.2

Chain lubrication

To lubricate the chain (1):
- Switch off the tool and remove the battery (16),
- Place the tool on a flat surface with the front guard (5) upwards,
- Put oil in the visible area between the bar (2) and the chain (1),
- Reassemble the battery (16) and switch the tool on. Oil gets distributed over the entire chain. Now the chain is lu-
bricated.
During ordinary tool working, lubricate the chain at least every half hour.
Use and maintenance manual – Translation of
original Instruction.: 00, Date 30/08/2021
Compulsory adequate clothing
Compulsory hand protection
Compulsory feet protection
Page 29