Tool Composition; Technical Data; Safety Devices - CAMPAGNOLA T-CAT Manuel D'utilisation Et D'entretien

Tool composition

Pos. Denomination
1 Chain
2 Bar
3 Locking nut
4 Adjusting screw
5 Front guard
Releasing switch
6
7 Operating lever
8 Hand guard
9 Display
10 ON/OFF button
11 Handle
12 Battery compartment
13 Chain guard
14 Bumper
15 Bar guard
16 Battery
Releasing plates
17
18 Battery charger
19 LED light indicators
20 Connecting cable

Technical data

Dati tecnici
Bar length:
4" bar maximum cut:
Cutting chain:
Active safety device
Variable speed
Chain speed
Battery cutting performance
Battery rated voltage
Li-Ion battery
Charge voltage
Charge duration
Tool weight w/o battery
Battery weight
Total tool weight

Safety devices

• ON/OFF button (10): Switches the tool on and off.
• Switched-on display (9): Indicates that the tool is powered by the battery (16).
• Releasing switch (6): Gets automatically engaged, when the operating lever (7) is released, and prevents from any
accidental tool operation.
• Bar guard (15): Protects the cutting bar (2) during transport.
• Chain guard (13): Protects the operator against any kickback effect.
• Hand guard (8): Protects the operator's hand against any contact with the chain (1), if this should break or get out
of the bar (2).
Page. 28
Function
Cuts branches, trunks, etc
Drives the cutting chain
Locks the bar
Regulates the chain tension
Protects the pinion and the bar chain
Allows to start the tool safely
Is pressed to operate the tool
Protects the operator's hand from the risk of touching the chain
Indicates whether the tool is on or off and shows the information
about the tool and battery status.
Switches the tool on and off
Allows to hold the tool
Is the battery seat
Protects the operator from any kickback
Supports the tool on the trunk during use
Protects the chain when the tool is not used
Allows to operate the tool
Allow to plug the battery into the tool or to remove it
Charges up to two batteries at the same time
Show the battery charge status
Connects the battery charger to the power outlet.
4"
Ø 100 mm
29 teeth, 1/4"
YES
YES
6 m/sec
Approx. 80 cuts of 8 cm Ø
10.8 V
10.8 V 2.5 Ah
AC110V-220V
1.5-2 h per battery
800 g
190 g
990 g
Use and maintenance manual – Translation of
original Instruction.: 00, Date 30/08/2021