Symbols And Warnings; Tool Assembling On The Extension Pole; Mains Connection; Packing And Handling - CAMPAGNOLA STAR 40 Manuel D'utilisation Et D'entretien

Symbols and warnings

General warning
Compulsory reading of the Use
& Maintenance Manual
Compulsory head and acoustic
protection

Tool assembling on the extension pole

• Mount the extension pole on the tool (clockwise) by screwing it onto the fitting (15) until it locks; for dismounting turn
anticlockwise.

Mains connection

• Check that the safety catch (5) is engaged.
• Adjust the pressure at 1000 kPa (10 bar).
• Check the good condition of the mesh filter positioned against the connector (16). If necessary, wipe any residue.
• Connect the supply hose to the fitting (16) having first made sure that the fitting is thoroughly clean. Its inner diam-
eter must be at least 6 mm.
Never work on trees or ladders, since it is extremely dangerous.
Before starting any task with the tool, wear protective clothes. Check that all the safety and protection devices
can perfectly work and have been exactly assembled.

Packing and handling

The tool is packed and carried by the manufacturer to the customer in a carton box. The packaged unit weight is 1 kg,
so it can be easily carried without any special help.
The handling of loads must be carried out in compliance with the current workplace safety rules. Use the box
for storing the tool for medium or long periods or for sending the packed product to a Service Point for repairs.

Control devices

To start the tool, keep the safety catch (5) in its forward position while pulling the operating lever (3). To stop the tool,
release the operating lever (3).

Using the tool

Always wear adequate and suitable safety clothing for the work to be carried out. Wear a protective helmet and
make sure that your clothes are fitting to the body. Avoid wearing neckties, necklaces, belts or long hair not
tied as they can be caught between the moving parts
When holding the tool in your hand, perform the following operations:
a) Carefully put a branch in the shear then, manually tighten the lever (3) operating the tool and cut the branch.
b) Once the branch has been cut, release the operating lever (3) and repeat the operation from step a).
Pag. 24
Compulsory adequate clothing
Compulsory hand protection
Compulsory feet protection
Use and maintenance manual – Translation of
original Instruction Rev.: 01, Date 10/11/2021