Important - Peg-Perego viaggio O+1 Switchable Notice D'emploi

stricter type approval criteria than previous models that
do not have type approval labels.

IMPORTANT

• "Viaggio 0+1 Switchable" must be installed in a
rear-facing position when used as a Group 0+ car
seat and in a forward-facing position when used as
a Group 1 car seat.
• Do not install "Viaggio 0+1 Switchable" on rear- or
sideways-facing vehicle seats.
• When used as a Group 0+ car seat on the vehicle's
front seat, the front airbag must be disabled.
• When used as a Group 1 car seat on the vehicle's
front seat, the car seat should be positioned as far
as possible from the dashboard.
• This item has a progressive serial number.
• If you experience any difficulty fitting "Viaggio
0+1 Switchable", lift up or remove the vehicle's
headrests.
WARNING
• Read the instructions carefully before use and keep
them in the folder provided for future reference.
Failure to closely follow the car seat installation
instructions will put your child at risk.
• "Viaggio 0+1 Switchable" must be assembled and
installed by adults.
• The car seat must be assembled and installed when the
child is not seated in it.
• When travelling in the vehicle, never hold your child in
your arms or allow him/her to sit on the vehicle seats.
In the event of sudden braking, even at low speeds, the
child might easily be flung forward.
• Do not insert fingers into the mechanisms.
• When travelling take special care to make sure that
luggage or other objects do not injure the child sitting
in the car seat in the case of an accident.
• Do not use installation methods other than those
indicated; this would result in the risk of detachment
from the seat in the case of an accident.
• Ensure that the vehicle's three-point seatbelt fixing the car
seat is always taut and not twisted. It should be replaced
in the case of heavy stress as a result of an accident.
• Never leave your child unattended in the car seat:
watch him/her even when s/he is sleeping.
• Never remove the child from the car seat when the
vehicle is in motion.
• Make sure that the car seat is not blocked by a mobile
part of the vehicle seat or by a door.
• Adjust the height and tension of the shoulder straps,
ensuring that they are as snug to the child's body as possible
without constricting him/her too much. Check that the
harness is not twisted and that the child does not release it.
• This car seat is not intended for prolonged periods of
sleeping.
• Do not leave the car seat in the vehicle when exposed
to the sun. Some parts might heat up and be harmful
to the delicate skin of your child. Check the seat is not
too hot before seating your child.
• Do not use the car seat without its fabric cover; this
must not be replaced with one not approved by the
manufacturer since it is an integral part of the car seat
and the safety system.
• If in doubt, contact the manufacturer or retailer of the
car seat.
• Do not remove the adhesive and stitched labels since
this might make the product not compliant with legal
requirements.
• Do not use the car seat if it has signs of breakage or missing
parts, if it is second-hand or if it has been subjected to
heavy impacts in an accident, because it might have
suffered extremely dangerous structural damage.
• Do not alter the product.
• For any repairs, replacement parts and information
about the product, contact the after-sales assistance
service. Contact information is provided on the last
page of this manual.
• The car seat must always be secured in the vehicle,
even when the child is not sitting in it; in the event of
sudden braking, it could injure the passengers.
26