Blackmagic Design Pocket Cinema Camera Manuel D'installation Et D'utilisation page 298

3
For safe storage of the battery compartment cover,
clip it into the recess on the underside of the battery
grip tray.
5
Insert the battery shaped part of the camera grip
into the battery compartment of your camera. The
1/4 inch screw on top of the battery grip should line
up with the 1/4-20 mounting point on the base of the
camera. A small pin next to the 1/4 inch screw helps
maintain correct alignment.
Inserting Batteries into the Battery Grip
1
Twist the locking tab on the end of the battery
grip anticlockwise to unlock the battery tray. Slide
out the battery tray. You can do this before or
after attaching the battery grip to your camera.
4
Close the battery compartment cover so it sits level
with the underside of the battery grip tray.
6
Turn the knob on the front of the battery grip to
the right to tighten the screw firmly and secure the
battery grip to the camera.
2
Place two NP-F570 batteries into the battery
tray, being careful of their orientation, and slide
them away from each other. A tab between the
batteries moves up to lock the batteries into place.
When you want to remove the batteries, press
down on this locking tab and slide the batteries
toward each other.
Using a Battery Grip 142