Blackmagic Design Pocket Cinema Camera Manuel D'installation Et D'utilisation page 297

3
For safe storage of the contacts cover from the
underside of camera, insert it into the recess on
top of the battery grip and secure it in place by
tightening the screw.
5
Turn the knob on the front of the battery grip to
the right to tighten the screw firmly and secure the
battery grip to the camera.
Attaching Blackmagic Pocket Camera Battery Grip
Before you start attaching a battery grip, switch off your Pocket Cinema Camera 6K or Pocket
Cinema Camera 4K and unplug any external power source.
1
Open the camera battery compartment and remove
the LP-E6 battery.
4
Gently push the camera grip onto the underside
of your camera. The 1/4 inch screw on top of the
battery grip should line up with the 1/4-20 mounting
point on the base of the camera. Small pins on both
sides of the 1/4 inch screw help maintain correct
alignment.
2
Slide the tab near the hinge of the battery
compartment cover and remove the cover
from the camera.
Using a Battery Grip 141