Blackmagic Design Pocket Cinema Camera Manuel D'installation Et D'utilisation page 188

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10
HDMI
The full size HDMI connector supports 10-bit 4:2:2 1080p HD video with support for
HDR and two channels of embedded audio. Use the touchscreen menu to set a clean
feed or include overlays on the output. You can use the HDMI port to connect to an
external monitor, recorder or ATEM Mini switcher. Connecting the camera via HDMI to
ATEM Mini gives you studio camera features such as remotely controlling recording and
adjusting many settings of Pocket Cinema Camera. It is a good practice to setup
external equipment and plug in all cables before you switch on your camera and
accessories. Always use high quality cables for HDMI connections.
11
Power Input
You can use the DC jack to power your camera and trickle charge the battery at the
same time. To connect the power adapter, rotate the plug so it aligns with the recess at
the top of the jack, then push in the plug until it locks. To disconnect the power plug,
retract the locking sheath, then pull out the plug.
Custom Power Solutions
Some customers have been creating custom made power devices as a means to
power their Blackmagic Pocket Cinema Camera. If you are creating your own
power solution with a dummy battery, caution needs to be taken to make sure
you are not supplying too much voltage to your camera, as this can cause
permanent damage. The voltage requirements of the Pocket Cinema Camera
are as follows:
– The battery input connection is rated from 6.2V to 10V max.
– The DC input is rated from 10.8V to 20V max.
– The camera requires 16W when in standby and is not charging the battery.
– The camera requires 30W when charging its internal battery.
– When powering your camera with a custom made power source, we recommend
removing its internal battery.
– When recording to external media with an active lens, full screen brightness,
full tally brightness, high frame rates and not charging the battery, Pocket
Cinema Camera 6K requires 25W and Pocket Cinema Camera 4K requires 22W.
Pocket Cinema Camera 6K Pro in the same configuration with the addition of
the viewfinder requires 26W.
12
USB
The USB-C port lets you record directly to an attached USB-C flash disk. When
your camera is switched off, you can recharge its battery via the USB-C port from an
external source such as a battery pack. To update your camera's internal software,
connect the camera to a computer via the USB-C port and run the camera
update application.
13
Mini XLR Microphone Input
Pocket Cinema Camera 6K Pro has two XLR audio inputs. Pocket Cinema Camera 6K
and Pocket Cinema Camera 4K have one XLR input.
Plug in external balanced analog audio via the mini XLR connector. A standard XLR
microphone can be connected to your camera using an XLR to mini XLR adapter cable.
The mini XLR input provides phantom power for connecting professional microphones
that aren't internally powered. For more information on enabling phantom power refer
to the 'audio' section in this manual.
Camera Features
32

Publicité

Chapitres

Table des Matières
loading

Table des Matières