To pair your camera with an iPad for the first time:
1
Enable Bluetooth by tapping the 'Bluetooth' switch icon in the 'setup' menu.
2
Open the 'Blackmagic Camera Control App' and select the camera you would like
to pair it with. Available cameras are listed by a camera letter, followed by a unique
hardware ID. For example A:A0974BEA.
Select the Blackmagic Pocket Cinema Camera you would like to pair with
When you install the Blackmagic Camera Control App and run it for the first time, you
will be asked if you want to 'allow location access.' If you select 'while using the app,'
GPS readings from your iPad will be included in the metadata of the files you shoot,
allowing you to geotag your footage. This information can be viewed in Blackmagic
DaVinci Resolve version 15 or higher.
If you do not want to allow the use of this information, select 'never.'
To change settings, go to settings, privacy, location services, camera control on
your iPad.
3
When you try to connect for the first time the Blackmagic Camera Control App will
request a six digit code to pair with the camera. This code will be displayed on the
camera's LCD screen. Type this code into the iPad and press 'pair'.
Settings
83